Gembird SIS-PMS-LAN - Manual (Page 13)

13
SIS-PMS-LAN PROGRAMMABLE SURGE
PROTECTOR WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
remove the excessive load first and then press the Circuit breaker
button to restore the power supply (see figure #3 above).
To be able to use SIS-PMS-LAN you will now have to complete its
LAN configuration.
3.2. Preparing LAN configuration of SIS-PMS-LAN
Before configuring SIS-PMS-LAN hardware settings, please, let it
obtain its IP address. Follow the steps below:
• Make sure SIS-PMS-LAN is connected to the local network with the
provided RJ-45 cable (option A - recommended)
NOTE: you may prefer to connect SIS-PMS-LAN directly to the
managing computer LAN adapter (network card) using the supplied
crossover RJ-45 cable (option B)
• Turn SIS-PMS-LAN off (with the Main rocker switch Z)
• Press IP Config (C) button on the side control panel (see figure #2
above) with the tip of a pen
• While holding it pressed, turn the Main rocker switch Z on and wait
for about 3 seconds until you hear the sockets switching twice
The above-mentioned procedure forces SIS-PMS-LAN to reset itself
to the default settings (see below) ...