Gembird SIS-PMS-LAN - Manual (Page 12)

12
SIS-PMS-LAN PROGRAMMABLE SURGE
PROTECTOR WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
• The sockets: Socket 1, Socket 2, Socket 3 and Socket 4 can be
managed or pre-programmed by computer via LAN. They are called
manageable sockets in this manual.
• The manageable sockets of SIS-PMS-LAN can be programmed to
be on or off. The current status of each manageable socket is
represented by the corresponding indicator which will be lit if socket
has power to it.
• If the Main rocker switch (Z) (see figure #1 above) is turned off then
the manageable sockets cannot be switched on by either web server,
Power manager software or the hardware schedule.
• As soon as you turn the Main rocker switch (Z) on then the web
server, Power manager software or the hardware schedule will be
able to turn the manageable sockets on and off.
• Master switch button (B) (see figure #2 above) can also switch all
the manageable sockets on and off regardless of their current status
or schedule that is being executed. To switch them on you should
keep the button pressed for 1-2 seconds. To switch them off you
should keep the button pressed for more than 3 seconds.
• To protect the connected devices from possible high current and
short circuit SIS-PMS-LAN is equipped with the automatic circuit
breaker.
• NOTE: If the total power consumption (or peak power) of the
devices, connected to SIS-PMS-LAN exceeds 2200 Watts, the
circuit breaker may power SIS-PMS-LAN off. In this case, please,