Xerox SquareFold Trimmer - Manual (Page 8)

User Guide 4
Overview SquareFold Trimmer Module
1a.
1b.
1c.
1d.
1.
2.
2a.
2b.
The Control Panel consists of the following:
Fault indicators: These indicators light when a fault or jam occurs in a particular area of the SquareFold
Trimmer Module.
This indicator lights when a jam occurs as the booklet is leaving the exit area of the finisher.
This indicator lights when a jam occurs in the square fold area.
This indicator lights when a jam occurs in the trimmer area.
This indicator lights when the Trimmer Waste Container is pulled out or when it is full.
2.
1.
1b.
1c.
1d.
2a.
2b.
If one of these indicators ( 1a, 1b, 1c) is lit, the top covers can be opened, and the jam/fault cleared; otherwise,
during normal operation or when the machine is idle, the top covers cannot be opened. For information on
jam/fault clearance, refer to page 15.
1a.
Control panel
Tip
Square Fold options: This area of the control panel contains the following:
Settings button: Press this button to adjust the Square Fold setting; refer to the next item.
Square Fold option: Select the desired setting; these settings are discussed in more detail on page 7.
The Square Fold options (as outlined below) are available from both the machine's User Interface (UI) and from your
workstation's print driver for this machine. This is discussed in more detail in the section entitled "Square Fold options."
Note