Xerox SquareFold Trimmer User Manual
Page 23

User Guide
19
Problem solving
SquareFold Trimmer Module
Fault code
Possible cause
Recommended solution
A top cover is open.
Open the Top Left and Right Covers of the SquareFold
Trimmer Module.
1.
2. Close the SquareFold Trimmer Module Top Left and Right
Covers.
The Trimmer Waste Container is full or
has a fault.
Pull open the container and empty any trimmer scraps from
it.
1.
2. Reinsert the container into the SquareFold Trimmer Module.
Ensure that the container is fully pushed in, and that the
indicator light is not lit.
3.
If fault persists, call for service.
4.
If fault persists, repeat Steps 1-3.
4.
If fault persists, power off/on the copier/printer.
5.
If fault persists, power off/on the copier/printer.
3.
If fault persists, call for service.
6.
Booklet Tray on the SquareFold
Trimmer Module is full.
Remove any booklets from the tray.
1.
If fault persists, power off/on the copier/printer.
2.
If fault persists, call for service.
3.
- 4112-4127 Enterprise Printing System-4614 4112-4127 Enterprise Printing System-6658 4112-4127 Enterprise Printing System-3361 4112-4127 Enterprise Printing System-185 4112-4127 Enterprise Printing System-204 4112-4127 Enterprise Printing System-3380 4112-4127 Enterprise Printing System-6677 4112-4127 Enterprise Printing System-4633