Xerox SquareFold Trimmer - Manual (Page 5)

User Guide 1
The SquareFold Trimmer Module is an optional finishing device
that is used in conjunction with another optional finishing device
that contains a booklet maker.
The SquareFold Trimmer Module:
Receives the booklet from the booklet maker area of the finisher, •
Flattens the booklet spine, thereby reducing the booklet’s thickness and giving it the appearance of a perfect- •
bound book, and
Trims/cuts away the face (edge) of the booklet, resulting in a neat finished edge.
•
Always refer to the Hints and Tips section of this manual before using the SquareFold Trimmer Module. The Hints and
Tips section provides valuable information about setting up your jobs, which in turn ensures the best possible output for
your print/copy jobs.
The booklet is assembled and stapled in the booklet area of the finisher; therefore, the booklet enters the SquareFold
Trimmer Module already assembled.
Any adjustments to the image of the original and its placement on the booklet
page must be done either from the machine’s UI or from your print driver.
You may want to run one or more test prints/copies before running larger jobs.
Introduction
Overview
Note
The SquareFold Trimmer Module requires a finisher with a booklet
maker attached.
Tip
Note
Tip