Zoom 0335-A 27337 - Manual (Page 21)

Chapter 3: Specifying TCP/IP Settings 21
Debian
Depending on what you want to do, specify the appropriate
TCP/IP settings as shown in the tables below.
Dynamic IP Addressing
Add this line to the file /etc/network/interfaces:
iface eth0 inet dhcp
Reboot with this command: /sbin/shutdown -r now
Static IP Addressing
Add the following lines to the file /etc/network/interfaces, but
include the values for address, netmask, and gateway
provided by your Internet service provider next to the
appropriate label:
iface eth0 inet static
address
netmask
gateway
Add the following lines to the file /etc/resolv.config, but
include the values for address, netmask, gateway, and dnc-
nameservers provided by your Internet service provider next
to the appropriate label:
iface eth0 inet static
address
netmask
gateway
dns-nameservers
Reboot with this command: /sbin/shutdown -r now
Logging into the Zoom Configuration Manager
Add these lines to the file /etc/sysconfig/network/ifcfg-eth0:
BOOTPROTO=”static”
BROADCAST=”10.0.0.255”
IPADDR=”10.0.0.10”
NETMASK=”255.255.255.0”
NETWORK=”10.0.0.2”
(Note that for IPADDR, you can enter any value
between 10.0.0.4 and 10.0.0.20.)
Reboot with this command: /sbin/shutdown -r now