Zebra Technologies TTP 7030 - Manual (Page 38)

Programming
Text Commands 38
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Moves the print-position one step to the left. Backspace can be used to combine characters.
For instance to print a Ø, send text commands O BS / to the printer, and the slash will
overprint the O.
Only one backspace can be used at a time. Excessive backspaces will be ignored.
Cancels text and attributes sent before the command on the same line.
Commands, are not cancelled.
By default, carriage return is ignored.
By changing the default settings, you can:
1.
Interpret is as which returns print position to beginning of line without line feed.
2.
Interpret as which inserts line space as specified by the line spacing
setting (see parameter p13), and returns the print position to beginning of the line.
See “Carriage return and line feed behavior” under
CR/LF Behavior on page 78
.
Linefeed is interpreted as by default. This inserts line spaces as specified by the
line spacing setting (see parameter p13), and returns the print position to beginning of the line.
also converts text from the input buffer to pixel lines and stores them in the line buffer,
ready to be printed.
By changing the default settings, you can:
1.
Interpret as Linefeed. This inserts line space as specified by the line spacing setting
(see parameter
13 on page 77
), without returning the print position to the beginning of the
line.
2.
Ignore .
See CR/LF Behavior on page 78 .
BS
Backspace 08 Hex
8 Decimal
CAN
Cancel
18 hex
CR
Carriage Return 0D hex
13 decimal
LF
Linefeed 0A hex
10 decimal