Fitting a shutter, Standard printer, Printer with retract – Zebra Technologies TTP 7030 User Manual
Page 103
103
Maintenance
Fitting A Shutter
10/05/2009
TTP 7030™ Technical Manual
P1003636-002
Fitting A Shutter
Figure 23 • Fitting a Shutter
The shutter kit contains a shutter and two hub-screws. In addition to this, you need an 1.5 mm
Allen-key.
1.
Fit one hub screw.
2.
Hook the shutter onto the screw and insert the other screw, through the hole in the shutter
and into the thread in the printer.
3.
Make sure the head of the screw goes into the hole of the shutter and then tighten it.
4.
Verify that the shutter opens/closes as it should by printing a couple of documents.
Standard
printer
Allen screw/hub (2x)
Printer with
retract
Shutter
See also other documents in the category Zebra Technologies Printers:
- TLP 2824 (60 pages)
- 400 (78 pages)
- 2824 (21 pages)
- S600 (94 pages)
- Printers (69 pages)
- 2844 Printer (47 pages)
- P310i (43 pages)
- 3742 (30 pages)
- R-140 (126 pages)
- ZEBRA Z4M H-974 (57 pages)
- P520i (2 pages)
- Mobile Printer (40 pages)
- R110XiTM (184 pages)
- XiIII Series (116 pages)
- PrintServer (157 pages)
- Z4000 (98 pages)
- Z SERIES 79695L-002 (156 pages)
- ZEBRA P205 (42 pages)
- 105Se (106 pages)
- 2722 (30 pages)
- Zebra S Series 105SL (130 pages)
- XiIIIPlus (40 pages)
- Zebra LP 2824-Z (62 pages)
- ZEBRA XI4TM (190 pages)
- P310C (46 pages)
- R170XI (184 pages)
- R402 (72 pages)
- SL5000r/T5000r (50 pages)
- T402 (62 pages)
- Zebra P330i (66 pages)
- Zebra Z6000 (98 pages)
- XiII-Series (118 pages)
- P1013372-001 REV. A (216 pages)
- ZebraNet ZM600TM (130 pages)
- RW SERIES (84 pages)
- LP 2824 (56 pages)
- TTP 8000 (132 pages)
- ZEBRA QL UMAN-QLP-001 (86 pages)
- LP 2844 (54 pages)
- LP2443 (24 pages)
- RXI SERIES (UHF) (19 pages)
- Zebra P120i (78 pages)
- DA402 (56 pages)
- P320i (49 pages)