Zebra Technologies TTP 7030 - Manual (Page 19)

19 Installation
Making A Test Printout
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Making A Test Printout
1.
Is a power button available for the printer?
If… Then…
Yes a. Remove power from the printer.
b.
Hold the feed-forward button depressed while powering ON the printer.
c.
Keep the button depressed until printing starts. 
This produces a printout showing the firmware program version and date,
control board revision number and serial number, name of loaded fonts and
logotypes, and the parameter settings.
d.
Each successive press of the button will produce a test printout.
e.
Switch the printer OFF and ON again to exit self-test mode.
No
a.
Lift the printhead.
b.
Press and hold the Feed button while lowering the printhead, and keep it
pressed until after the auto-load is completed.
c.
Release the button.
A self-test printout will be printed.
Note •
this feature was introduced in firmware version 2.44b.