ZyXEL Communications ZyXEL ExpWave 240B - Manual (Page 64)

ExpWave 240B Secure Outdoor Ethernet Radio Link
10-2 SNMP Configuration
• Set - Allows the manager to set values for object variables within an agent.
• Trap - Used by the agent to inform the manager of some events.
10.2 Supported MIBs
The ExpWave supports MIB II that is defined in RFC-1213 and RFC-1215. The focus of the MIBs is to let
administrators collect statistical data and monitor status and performance.
10.3 SNMP Configuration
To configure SNMP, enter 22 from the main menu to display Menu 22 - SNMP Configuration as shown next. The
“community” for Get, Set and Trap fields is SNMP terminology for password.
Figure 10-2 Menu 22 — SNMP Configuration
The following table describes the SNMP configuration parameters.
Table 10-1 SNMP Configuration Menu Fields
FIELD DESCRIPTION EXAMPLE
Get Community Type the Get community, which is the password for the incoming
Get- and GetNext requests from the management station. Public
Set Community Type the Set community, which is the password for incoming Set
requests from the management station. Public
Trusted Host If you enter a trusted host, your ExpWave will only respond to
SNMP messages from this address. A blank (default) field means
your ExpWave will respond to all SNMP messages it receives,
regardless of source. 0.0.0.0
Trap
Community
Type the Trap community, which is the password sent with each
trap to the SNMP manager. Public
Destination Type the IP address of the station to send your SNMP traps to. 0.0.0.0
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
10.4 SNMP Traps
The ExpWave will send traps to the SNMP manager when any one of the following events occurs:
Table 10-2 SNMP Traps
TRAP # TRAP NAME DESCRIPTION
0 coldStart (defined in RFC-1215) A trap is sent after booting (power on).
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: