ZyXEL Communications Omni TA128 - Manual (Page 32)

20
(ATS83.7=1). This function is useful in the areas where ISDN
service providers charge lower usage rate for voice (speech) calls.
To enable this function, type:
ATS83.7=1
To disable it, type:
ATS83.7=0
Dialing out for Analog Adapter Port 1
Using the “A” command following the “ATD” will tell your
TA128 to automatically switch call to analog adapter, Phone 1,
once dialing is complete.
Type:
ATDA17146930762
O O NOTE
: You must have an analog modem connected to your analog port
before you issue this command.
Dialing out for Analog Adapter Port 2
Using the “B” command following the “ATD” will tell your TA128
to automatically switch calls to analog adapter Phone 2, once
dialing is complete.
Type:
ATDB17146930762
Manually switching communication modes
The manual switching functions will only be necessary if your
communication software does not allow you to change your dial-
up string.
Conventional dialing commands: ATD, ATDT and ATDP, used by
many existing communication software, can be mapped onto one
of the new dialing commands according to the AT&O setting as
follows: