ZyXEL Communications Omni TA128 - Manual (Page 102)

90
Level 1 Level 2 Level 3
Password Check Yes Yes Yes
CPN Check OK
and S119.6=0 N/A Call back Prompts
the remote
user to
enter call
back
number
CPN Check OK
and S119.6=1 N/A Keep the
connection for calling
back.
CPN unmatched N/A Disconnect
CPN not
Available N/A Call back using
the
corresponding
pre-stored
number
AT Commands *G1 for
Type 1
*G3 for
Type 2 *G2 for Type 1
*G4 for Type 2 *G5 for
Type 2
Setting and Modifying Passwords
Up to 40 user passwords can be defined using the AT*Hn
command, where “n” represents the index to the entry. Numbers
between 0-39 are accepted.
The corresponding 40 call-back numbers are defined by
AT&Zn=xxx command, where “n” represents the index to the
entry, and “xxx” represents the assigned call-back phone number.
Any character (ASCII 0-127) can be used in the password table, the
maximum password length is 8 characters for each entry.
Security functions are only accessible through AT commands in
terminal mode. A supervisory password is required for adding or
modifying entries. The default supervisor password is ZyXEL