ZyXEL Communications Omni TA128 - Manual (Page 31)

19
Use “A/” to repeat the last command. No ‘AT’ prefix is needed for
this command.
The TA128 supports either verbose result code (i.e. “OK”) or
numerical result code (i.e. “0"). You can use ATVn command to
set it one way or the other:
Command Description
ATV0 Select numerical result code.
ATV1 Select verbose result code.
Outgoing Calls
The TA128 has 3 modes in which to send communication over
ISDN network.
•
ISDN data.
•
Analog port, Phone 1 communication.
•
Analog port, Phone 2 communication.
These modes are auto-switching based on the commands you
issue. Let’s take a look at how the communication mode is
automatically switched. At your terminal program, proceed with
the following instructions:
Dialing out using ISDN mode
The command “ATDI” tells your TA128 that you want to make an
ISDN data call and to therefore use the ISDN mode to call out.
Type:
ATDI17142630398 (Make an ISDN call)
Dialing out using ISDN mode’s optional Speech Bearer
Service
TA128 supports ISDN data utilizing Speech Bearer Service. To
enable this function, you need to set S-register S83 bit 7 to 1