Yamaha RX-Z11 - Manual (Page 51)

Optimizing the speaker setting for your listening room (YPAO)
51
En
Prepara
tion
3
Press I
MENU on the remote control.
Following menu screen appears in the video monitor.
4
Press 9k to select “Setup Menu” and then 9h.
The list of the measurements in the automatic setup appears in
the screen.
5
Press 9k repeatedly to select “Multi Measure”.
6
Press 9h and then 9k / n repeatedly to set the
number of the listening positions you want to make
the measurement at.
Choices: 1, 2, 3, 4, 5, 6, 7, 8
7
Press 9l to return to the previous menu level and
then press 9n repeatedly to select “Angle”.
8
Make sure that a check mark appears in the check
box of “Angle”.
If the check mark does not appears, press 9ENTER to select
the check box.
9
Once you have finished the settings, press 9l to
return to the previous menu level and then press 9n
to select “Start”.
This unit starts the measurement procedure. See page 48 for
details.
10
Once this unit pauses the automatic measurement
procedure and then “Put the microphone at 2nd
listening position” appears in the display, move the
optimizer microphone to the listening position
2.
11
Press 9
ENTER to start the measurement at the next
listening position.
y
To skip the measurements at the remaining listening positions, press
9
n.
12
Repeat steps 10 and 11 until the measurements at all
listening points are completed.
13
Once following display appears in the video monitor,
place the supplied microphone base at the listening
point you want to be seated most frequently as
follows.
Make sure that the arrow mark on the microphone base points
the center speaker or between the front left and right speakers.
For the accurate measurements of the speaker angles, we strongly
recommend that you use a tripod (etc.) to affix the microphone base at
the same height as your ears would be when you are seated in your
listening position. You can use the attached screw of a tripod (etc.) to
fix the microphone base to the tripod (etc.).
14
Place the optimizer microphone to the “(1)” position
on the microphone base.
Information
Setup Menu
Start Start:ENTER
✓
✓
✓
3
Information
Setup Menu
Start
Multi Measure
Wiring
Distance
Pre Check
Main Check
Wiring
Distance
Put the microphone at
2nd listening position
Next:ENTER
Skip:
Note
1
2 3
FRONT DIRECTION
Equalizing
Level
Angle Check
Angle
Result
Put the microphone at
1st listening position
Next:ENTER
Microphone base