Yamaha RX-Z11 - Manual (Page 30)

Connections
30
En
■ Audio signal flow
• 2-channel as well as multi-channel PCM, Dolby Digital and DTS signals
input at the HDMI input jacks can be output at the HDMI OUT jacks only
when “Support Audio” is set to “Other” (see page 113).
• The following types of audio signals can be only input at HDMI input
jacks:
– DSD
– Dolby TrueHD
– Dolby Digital Plus
– DTS-HD Master Audio
– DTS-HD High Resolution Audio
■ Video signal flow
y
You can deinterlace and convert the resolution of the video signals by using
“Video” parameters. See page 107 for details.
• When the analog video signals are input at the COMPONENT VIDEO, S
VIDEO and VIDEO jacks, the priority order of the input signals is as
follows:
1. COMPONENT VIDEO
2. S VIDEO
3. VIDEO
• This unit is equipped with the two COMPONENT VIDEO MONITOR
OUT jacks and HDMI OUT jacks. The COMPONENT VIDEO
MONITOR OUT 1 and 2 outputs the same video signals and you can use
both COMPONENT VIDEO OUT jacks simultaneously.
• Digital video signals input at the HDMI input jacks cannot be output from
analog video output jacks.
• The analog component video signals (with 480i (NTSC)/576i (PAL) of
resolution only) are converted to the S-video or composite video signals
and output at the VIDEO or S VIDEO MONITOR OUT jacks.
• The GUI signal is not output at the DVR OUT and
VCR OUT jacks and is not recorded.
Audio and video signal flow
Notes
DIGITAL AUDIO
(OPTICAL)
DIGITAL AUDIO
(COAXIAL)
HDMI
AUDIO
Output Input
Notes
S VIDEO
VIDEO
COMPONENT
VIDEO
HDMI
Through
Output Input
“Conversion”: “On” (see page 107)