Yamaha RX-Z11 - Manual (Page 28)

Connections
28
En
1
Remove approximately 10 mm (0.4 in) of insulation
from the end of each speaker cable and then twist the
exposed wires of the cable together to prevent short
circuits.
2
Loosen the knob.
3
Insert one bare wire into the hole on the side of each
terminal.
4
Tighten the knob to secure the wire.
■ Connecting the banana plug
Tighten the knob and then insert the banana plug
connector into the end of the corresponding terminal.
■ Using bi-amplification connections
This unit allows you to make bi-amplification connections to one
speaker system. Check if your speakers support bi-amplification.
To make the bi-amplification connections, use the FRONT A and
SUR.BACK/BI-AMP terminals as shown below. To activate the bi-
amplification connections, set “BI-AMP” to “ON” in “Advanced
setup” (see page 143).
When you make the conventional connection, make sure that the shorting
bars are put into the terminals of the speakers appropriately. Refer to the
instruction manuals of the speakers for details.
Connecting the speaker cable
10 mm (0.4 in)
Red line: positive (+)
White line: negative (–)
Caution
Remove the shorting bars or bridges of your speakers to separate
the LPF (low pass filter) and HPF (high pass filter) crossovers.
Note
Red line: positive (+)
White line: negative (–)
banana plug
+ R + L
(SINGLE)
SUR. BACK/
BI-AMP
FRONT B/
ZONE
FRONT B/
FRONT A
EXTRA SP
A
B
SUR. BACK/
BI-AMP
FRONT B/
ZONE
FRONT A
EXTRA SP
A
B
This unit
Left Right
Front speakers