Yamaha RX-Z11 - Manual (Page 12)

Getting started
12
En
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote control
sensor on this unit during operation.
6LIGHT
Lights up the remote control buttons and the display window (4).
Display window (4)
[1] ID1/ID2 indicator
Indicates the currently selected remote control ID (see
page 143).
[2] Transmit indicator
Appears while the remote control is sending infrared signals.
[3] Zone indicators
Indicates the currently controlling zone (see page 139).
[4] Information display
Shows the name of the selected input source that you can
control.
Infrared window (1)
Outputs infrared control signals. Aim this window at the component
you want to operate.
Operation mode selector (F)
The function of some buttons depends on the operation mode
selector position.
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input selector button
(see page 122).
TV
Operates the TV (see page 121).
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types of
conditions:
– places of high humidity, such as near a bath
– places of high temperatures, such as near a heater or stove
– places of extremely low temperatures
– dusty places
When you want to use the controls behind the front panel door, open
the door by gently pressing on the lower part of the panel. Keep the
door closed when not using these controls.
Using the remote control
MASTER MAIN ZONE
INPUT
ON OFF
MIC OPTIMIZER
AUDIO SELECT SPEAKERS A B
YPAO SILENT CINEMA
PHONES
ON/OFF
PURE DIRECT
VOLUME
MULTI
ZONE
STRAIGHT TUNING MODE
ZONE ON/OFF
MENU
TONE CONTROL ZONE CONTROLS REC OUT/ ZONE 2
MEMORY FM/AM EDIT PRESET/TUNING
EFFECT DISPLAY MAN'L/AUTO CATEGORY SEARCH MODE
PUSH ENTER
PROGRAM
R L OPTICAL
HDMI IN USB
AUDIO
VIDEO AUX
S VIDEO VIDEO ZONE 3 ZONE 4 ZONE 2
30 30
Approximately
6 m (20 ft)
Remote control sensor
MAIN
ZONE 2
ID 2 ID 1
ZONE 3
ZONE 4
[1] [2]
[3] [4]
Notes
Backlight mode
The remote control is equipped with the motion sensor and the
remote control lights up the backlight corresponding to the
motions or operation. If you do not want to lights up the
backlight when this unit detects motions, change the backlight
mode (see page 124).
Opening and closing the front panel door
To open, press gently on the lower part of the panel.