Yamaha RX-Z11 - Manual (Page 138)

Using multi-zone configuration
138
En
■ Using REMOTE IN/OUT and TRIGGER OUT jacks for Zone 2, Zone 3, and Zone 4
You can use the REMOTE IN/OUT and TRIGGER OUT jacks of this unit for Zone 2, Zone 3, and Zone 4 as well as the main zone. Refer to
“Using REMOTE IN/OUT jacks” and “Using the TRIGGER OUT jacks” on page 38 for more information.
REMOTE IN/OUT jacks
This unit is equipped with two REMOTE IN and REMOTE OUT jacks. You can use the REMOTE IN/OUT jacks to control this unit or other
component from Zone 2, Zone 3, or Zone 4.
The following diagram shows an example of the connections.
y
Some Yamaha models are able to connect directly to the REMOTE OUT jack on this unit. If you own these products, you may not need to use an infrared
emitter. Up to six Yamaha components can be connected as shown.
TRIGGER OUT jacks
This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the selection of the input
source of the desired zone or turning on and off the desired zone. Use “Trigger Output” in “Manual Setup” to set the functions of the
TRIGGER OUT jacks (see page 114).
REMOTE
OUT 1
2
IN 1
2
REMOTE
OUT
1
2
IN
OUT
IN
This unit
Remote control
signal in
Remote control
signal in
DVD player (etc.)
CD player (etc.)
Zone 2
Zone 3
Infrared signal
receiver
Remote control
Remote control
signal out
Remote control
signal out
Remote
control
External amplifier
OUT OUT IN
REMOTE
IN
REMOTE
OUT IN
REMOTE REMOTE
This unit Yamaha component Yamaha component Infrared signal
receiver
TRIGGER OUT 1
2
TRIGGER
OUT
1
2
This unit
Projector (etc.) in the
main zone
Zone 2 (etc.)
Power amplifier (etc.)
Trigger in
Trigger in