Zebra Technologies ZEBRA RXI4TM - Manual (Page 97)

97 Configuration
Standard Control Panel Parameters
1/7/10 Xi4™/RXi4™ User Guide P1009874-002
Set Printhead Life for Early Warning
This parameter appears only when Early Warning for Maintenance is
enabled. Set this value to the number of inches of media that the printhead
is expected to print.
Default Value: 1,000,000 inches
Range: 100 to 1,000,000 inches
To change the value shown:
1. Press MINUS (-) to move the cursor.
2. Press PLUS (+) to increase the value of the digit.
When the printhead reaches the set length, WARNING REPLACE
HEAD
appears on the LCD. If the alert function is enabled, the printer
generates an alert.
Reset Printhead Life Counter for Early Warning
This parameter appears only when Early Warning for Maintenance is
enabled.
To reset the printhead life counter:
1. Did you replace the printhead?
• If you replaced the printhead, press PLUS (+) to select
YES
.
• If you did not replace the printhead, press MINUS (-) to select
NO
.
View Non-Resettable Counter
This parameter displays the total length of media that the printer has
printed. You can use firmware commands to change the unit of measure
and reset this counter. Refer to the Programming Guide for the printer
language being used.
View User-Controlled Counter 1
This parameter displays the total length of media that the printer has printed
since this parameter was last reset. You can use firmware commands to
change the unit of measure and reset this counter. Refer to the
Programming Guide for the printer language being used.
View User-Controlled Counter 2
This parameter displays the total length of media that the printer has printed
since this parameter was last reset. You can use firmware commands to
change the unit of measure and reset this counter. Refer to the
Programming Guide for the printer language being used.
Table 8 • Printer Parameters (Sheet 7 of 22)
Language/Parameter Action/Explanation