Replacing printer components, Ordering replacement parts, Recycling printer components – Zebra Technologies ZEBRA RXI4TM User Manual
Page 116: Lubrication
Routine Maintenance
Replacing Printer Components
116
P1009874-002
Xi4™/RXi4™ User Guide
1/7/10
Replacing Printer Components
Some printer components, such as the printhead and platen roller, may wear out over time and
can be replaced easily. Regular cleaning may extend the life of some of these components. See
Cleaning Schedule and Procedures on page 117
for the recommended cleaning intervals.
Ordering Replacement Parts
For optimal printing quality and proper printer performance across our product line, Zebra
strongly recommends the use of genuine Zebra™ supplies as part of the total solution.
Contact your authorized Zebra reseller for part ordering information, or see
for contact addresses and telephone numbers.
Recycling Printer Components
Lubrication
Other than lubricating the cutter blade after approximately 60,000 cuts, no lubrication is
needed for this printer.
The majority of this printer’s components are recyclable. The printer’s main logic board
includes a battery that you should dispose of properly.
Do not dispose of any printer components in unsorted municipal waste. Please dispose of the
battery according to your local regulations, and recycle the other printer components
according to your local standards. For more information, see
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.
Caution • Some commercially available lubricants will damage the finish and the
mechanical parts if used inappropriately on this printer.