Xerox Phaser Printer EX7750 - Manual (Page 57)

2
2-17 Calibrating the EX7750 with the DTP41
11. Click Read Strip.
The DTP41 pulls the measurement page through automatically.
After the measurement page is read, Calibrator instructs you to insert and align the
page again for the next color.
12. Repeat the measurement process for the magenta, yellow, and black strips.
A check mark appears on the circle of the color just read, and the Status field indicates
the color was measured successfully.
Click Previous and Next to reverse or advance to another step in the measurement
sequence.
13. When the Status field indicates that all four color strips have been read successfully,
click Accept Measurements.
14. Click OK in the Measure dialog box.
15. Click Apply in the Calibrator window to implement the new calibration set.
16. Click OK in the Information dialog box.
This completes the EX7750 calibration process.