Winegard RD-9946 - Manual (Page 41)

41
Set Motor Positions Set Motor Positions is only used to lower antenna if limit switches have failed.
Refer to troubleshooting section on how this procedure is performed.
Test functions is used to test various components of the system, refer to
troubleshooting section on use.
Return to Defaults is used to return the positioner to factory settings. This
should only be done when instructed to do so by a qualified technician. Refer
to troubleshooting section on use.
System Information is used to determine what mount the positioner is set to
operate and what firmware version is used in the positioner. Refer to
troubleshooting section on use.
Test Functions
Return to Defaults
System Information