Winegard RD-9946 - Manual (Page 11)

11
W
ARNING
INDICA
T
O
R
IGN
46 CM 60CM
WINEGARD P/N:2750225
120 V
AC 60 Hz
100 W
A
TTS MAX
TO
RECEIVER
TO
ANTENNA
REMOTE CONTROL
P
ANEL
1 GREEN/BLACK
2 RED/BLACK
3 RED/WHITE
4 GREEN
5 RED
6 BLACK
7 ORANGE
8 BLUE
9 WHITE
10 BLACK/WHITE
11 ORANGE/BLACK
12 WHITE/BLACK
13 BLUE/BLACK
After all other connections are made connect AC power cord to 120 VAC
outlet
.
Figure 12
Optional RD-9901 Remote Control Wall Plate. Connected by 25' telephone-type wire with modular plug-in connections.
GOLD SILVER
Connect to vehicle ground. Connect to ignition +12 VDC.
Connect 13 pin connector here, makeing sure wire colors match. Secure connector to positioner with screws molded into connector.
Connect 75 ohm coaxial cable from antenna. Connect 75 ohm coaxial cable to SATELLITE IN jack on receiver.
This connection is optional. If used antenna will be put into travel position whenever the ignition is turned ON and there is AC power to the positioner.
Optional RD-9911 Warning Device Refer to Figure 15, Page 14 for operation and installation.
Rev. 6/98
Make sure switch is in the 46CM position. Switch removed 2/23/98.