Wayne-Dalton 9800 - Manual (Page 27)

Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
27
Rear Support
kEEP hORIzONTal TRaCk
PaRallEl aND WIThIN 3/4”
MaxIMuM OF DOOR EDGE,
OThERWIsE DOOR COulD Fall,
REsulTING IN sEVERE INjuRy OR
DEaTh.
Raise the door until the top section
and half of the next section are in a
horizontal position. Do not raise door
any further since rear of horizontal track
is not yet supported.
RaIsING DOOR FuRThER CaN
REsulT IN DOOR FallING aND
CausE sEVERE INjuRy OR
DEaTh.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side, just below the second
roller on the other side. This will prevent
the door from raising or lowering while
installing the rear support.
using perforated angle, 5/16” x
1-5/8”hex head lag screws and 5/16”
bolts with nuts (may not be supplied),
fabricate rear support for horizontal
tracks. attach horizontal tracks to
the rear supports with 5/16”-18 x
1-1/4” hex bolts and nuts (may not be
supplied). horizontal tracks must be
level and parallel with door.
NOTE: If rear supports are to be
installed over drywall, use 5/16” x 2”
hex head lag screws.
adjust weather seal or door stop (if
necessary) Now permanently attach
the weather seal or door stop to both
door jambs and header. (Temporarily
attached in PREPaRING ThE OPENING
on page 10.) avoid pushing weather
seal or door stop too tightly against face
of door.
22
WARNING
WARNING
Ratchet Wrench
1/2” socket
1/2” Wrench
Vice Clamps
DOOR IN ThE
uP POsITION
VERTICal
TRaCk
3/4”
VICE
ClaMPs
DOOR EDGE
hORIzONTal TRaCk
INST
ALLA
TION