Wayne-Dalton 8000 SERIES 46 - Manual (Page 31)

31
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
INST
All
ATION
Drum wrap Installation
Drum wraps are identified as right and
left hand.
To install, place the drum wrap over the
cable drum and under the
idrive ®
disconnect cable (right hand side). Align
the outside flange over the outside edge
of the cable drum and push the drum
wrap down onto the cable drum. Repeat
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
IMPORTANT: RIGhT AND LEfT hAND
ARE ALWAyS DETERMINED fROM
INSIDE ThE GARAGE LOOkING OuT.
None
Rear Support
kEEP hORIzONTAL TRACk
PARALLEL AND WIThIN 3/4”
MAxIMuM Of DOOR EDGE,
OThERWISE DOOR COuLD fALL,
RESuLTING IN SEVERE INjuRy OR
DEATh.
Raise the door until the top section and
half of the next section are in a horizontal
position. Do not raise door any further
since the horizontal tracks are not yet
supported at the rear.
RAISING DOOR fuRThER CAN
RESuLT IN DOOR fALLING AND
CAuSE SEVERE INjuRy OR DEATh.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side and below the second roller on the
other side. This will prevent the door from
raising or lowering while installing the rear
support.
using perforated angle, 5/16” x 1-5/8”
hex head lag screws and 5/16” bolts
with nuts (may not be supplied), fabricate
rear support for horizontal tracks. Attach
33
34
wARNINg
wARNINg
DOOR IN ThE
uP POSITION
VERTICAL
TRACk
3/4”
VICE
CLAMPS
DRuM
WRAP
CABLE
DRuM
OuTSIDE
fLANGE
DRuM
WRAP
CABLE
DRuM
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Tape Measure
Level
hammer
DOOR EDGE
hORIzONTAL TRACk