Wayne-Dalton 8000 SERIES 46 - Manual (Page 14)

14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed: Locate the lower (numbered) leaf of
the #1 end hinges and required center
hinges over the #1 and #4 holes in the
end stiles for the end hinges and the
pre-punched holes in the center stile(s)
for the center hinges at the top of the
section.
NOTE: The #1 hinges serve as end
hinges on the bottom section. The #1
hinges also serve as center hinges at all
center hinge locations.
Secure the hinges to the section using
(2) 1/4”-14 x 5/8” self tapping screws
on each hinge leaf.
Insert roller into appropriate hinge tube.
Repeat for all other sections using the
#2 end hinges on the second (lock
section) and the #3 end hinges on the
third section (intermediate section).
NOTE: #4 End hinges are used on fourth
section of five section doors.
IMPORTANT: WhEN PLACING ROLLERS
INTO END hINGES NuMBER 2 AND
hIGhER, ThE ROLLER GOES INTO ThE
TuBE fuRThEST AWAy fROM SECTION.
IMPORTANT: ONCE fASTENER IS
SNuG AGAINST hINGE LEAf, TIGhTEN
AN ADDITIONAL 1/4 TO 1/2 TuRN TO
RECEIVE MAxIMuM DESIGN hOLDING
POWER.
hinges
END STILE hOLE
PATTERN
(LEfT SIDE IS ShOWN.
RIGhT SIDE IS
OPPOSITE.)
7
6
5
4
3
2
1
#1 hINGE #2 END hINGE
#3 END hINGE #4 END hINGE
CENTER STILE
hOLE PATTERN
ROLLER
PLACEMENT
ROLLER
PLACEMENT
ROLLER
PLACEMENT
hINGE
(2) 1/4”-14 x 5/8”
SELf TAPPING
SCREWS
CENTER STILE
(2) 1/4”-14 x 5/8”
SELf TAPPING
SCREWS
hINGE
END STILE
END hINGE PLACEMENT
CENTER hINGE PLACEMENT
#4 hOLE
#1 hOLE
Power Drill
7/16” Socket
Driver
5