Wayne-Dalton 8000 SERIES 46 - Manual (Page 26)

26
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
25
uSING A TAPE MEASuRE, MAINTAIN AN EquAL MEASuREMENT “x” (TOP Of DOOR
TO BOTTOM Of TORquEMASTER® TuBE) AT BOTh ENDS AND ThE CENTER.
Power Drill
1/8” Drill Bit
7/16” Socket
Driver
Tape Measure
Positioning Support bracket
TOP SECTION
“x” “x” “x”
NOTE: See idrive ® main installation and
owners manual for idrive ® parts.
NOTE: idrive ® must be installed on a
solid mounting surface.
Locate the mounting surface. The
mounting surface is a vertical board
running directly above the center of the
door. Remove (2) 1/4”-20 flange nuts
from bottom of opener.
NOTE: Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. using a
tape measure, level the bottom of the
TorqueMaster
® spring tube to the top of
the door section with the idrive ® resting
on the support bracket. Once
TorqueMaster
® spring tube is level, drill
1/8” pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4” x 1-1/2" hex had
lag screws.
IMPORTANT: TORquEMASTER ® SPRING
TuBE MuST BE LEVEL AfTER SuPPORT
BRACkET IS fASTENED TO MOuNTING
SuRfACE.
NOTE: If wood mounting surface is
behind dry wall, use 1/4” x 2” lag
screws.
Lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. Loosely
fasten to mounting studs with the (2)
1/4”-20 flange nuts.
NOTE: Do not tighten 1/4”-20 flange
nuts to opener studs at this time.
Remove the temporary orange label
holding the antenna wire. Straighten
antenna wire and angle it 45 degrees to
the right.
NOTE: Do not coil the antenna wire.
This will reduce the radio signal range.
ANTENNA WIRE 45° ANGLE
1/4 x 1-1/2”
hEx hEAD
LAG
SCREWS
SuPPORT
BRACkET
1/4” - 20
fLANGE
NuTS
MOuNTING
STuDS
MOuNTING
SuRfACE
(hEADER)
TOP Of DOOR
(2) 1/4”-20
fLANGE NuTS
SuPPORT
BRACkET
MOuNTING
STuDS BRACkET
SLOTS
TORquEMASTER ®
SPRING TuBE
TORquEMASTER ®
SPRING TuBE