Wayne-Dalton 8000 SERIES 46 - Manual (Page 13)

13
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
INST
All
ATION
4
Drums
IMPORTANT: RIGhT AND LEfT hAND IS
ALWAyS DETERMINED fROM INSIDE ThE
GARAGE LOOkING OuT.
NOTE: for door section identification see
page 4.
TorqueMaster ® counterbalance drums
are marked right and left hand.
uncoil the counterbalance cables and
make sure you place the right hand
cable loop on the right hand milford pin
and place the left hand cable loop on the
left hand milford pin.
Insert a roller into bottom bracket of the
bottom section.
Repeat for other side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2” excess astragal on
either side, trim astragal even with door
section.
LEfT hAND
TORquEMASTER ®
COuNTERBALANCE DRuM
BOTTOM SECTION
MILfORD PIN
BOTTOM SECTION
ASTRAGAL
None
ROLLER
hINGE TuBE
BOTTOM
BRACkET
MILfORD PIN
COuNTERBALANCE
CABLE