Wayne-Dalton 8000 SERIES 46 User Manual

Page 21

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

INST

All

ATION

Center bracket bushing

NOTE: If you are installing an

idrive

opener on your garage door, skip this
step and continue with Step 19.

NOTE: If you are not installing an

idrive

opener on your garage door, you must
install the center bracket bushing
assembly. follow these instructions for
non-

idrive

operated garage doors.

NOTE: If you are installing a
DoorMaster™ opener, see optional
DoorMaster™ Bracket installations on
page 33, figure A.

Being cam shaped the center bracket
bushing only fits one way.

Slide the center bracket assembly
towards the center of the torque tube,
from the right side as shown.

NOTE: upon completion of this step,
continue with Step 20.

CENTER

BRACkET

ASSEMBLy

TORquEMASTER

SPRING TuBE

TORquEMASTER

SPRING TuBE

CENTER

BRACkET

BuShING

TorqueMaster

Spring Tube

TorqueMaster

springs come lubricated

and pre-assembled inside the
TorqueMaster

spring tube. To install, lay

the TorqueMaster

spring tube on the

floor (inside garage) in front of the door
with the labeled end to the left.

IMPORTANT: RIGhT AND LEfT hAND IS
ALWAyS DETERMINED fROM INSIDE ThE
GARAGE LOOkING OuT.

LABELED END

TORquEMASTER

SPRING TuBE

None