SUUNTO D9 - Manual (Page 54)

52
If the dive is started without that the D9 and the transmitter have been properly paired,
the D9 will indicate that no cylinder data is available by displaying “OFF” (Fig. 5.30e).
TABLE 5.3. PRESSURE TRANSMISSION RELATED DISPLAYS
Display Indication Figure 5.30
Cd:-- Set Code. No code stored, wrist unit ready for pairing a
with tranmitter.
- - - Pressure reading over 360 bar [5220 psi] b
FAIL Indicates pressure reading has not been updated in more than c
1 minute. Transmitter is out of range, in power saving mode or
on another channel. Activate the transmitter by breathing off the
regulator, and recode the wrist unit if necessary.
LOBT Indicates pressure transmitter battery voltage is low. d
Change the transmitter battery!
OFF Pairing has not been conducted before start of dive. e
No cylinder data available.