Wireless transmission setup – SUUNTO D9 User Manual

Page 50

5.2.9. UNITS

You can choose between metric (meters/celcius/bar) and im-
perial (feet/farenheit/psi) units. (Fig. 5.26.).

5.2.10. HP CODE

The HP Code setting allows the user to verify the selected
code and to erase the stored code and enable re-pairing if
needed.

5.3. WIRELESS TRANSMISSION SETUP

5.3.1. INSTALLING THE WIRELESS TRANSMITTER

Upon purchasing the D9, Suunto strongly recommends you
have your dealer attach the transmitter to the fi rst stage of
your regulator.

If you decide to attach it yourself, follow the steps outlined be-
low:

1. Remove the high pressure (HP) port plug on the fi rst

stage of your regulator using an appropriate tool.

2. Thread the high pressure transmitter of the D9 into

the HP port of your regulator with your fi ngers. DO
NOT OVERTIGHTEN! Maximum torque 6 Nm (4.4

Fig. 5.24 Wireless in-
tergartion disabled (off),
press up/down to activa-
te. Tank pressure alarm
is currently set to 35bar
pressure.

Fig. 5.25. Entering Unit
settings