SUUNTO D9 - Manual (Page 27)

25
The display is illuminated by holding down the M (Mode) but-
ton for more than two seconds.
When diving, the dive entry time and date is registered in the
Logbook Memory. Remember always to check before diving
that the time and date are correctly set, especially when tra-
veling to different time zones.
To set the time and date, refer to chapter 3.3 ”Time mode
Settings”.
3.2. STOPWATCH (TIMER)
The Stopwatch function is entered by pressing the UP or
DOWN buttons when in TIME mode until the stopwatch
display appears. (Fig. 3.1 d).
The stopwatch of the D9 lets you measure elapsed and split
times. The range of the stopwatch is 99 hours, 59 minutes,
59.9 seconds (Fig. 3.2).
The stopwatch is started by pressing the DOWN button and
stopped by pressing the UP button. The stopwatch is reset by
pressing the UP button for >2s.
There is also a separate stopwatch (dive timer) that can be
used when diving in the Gauge mode (see chapter 6.3.).
Fig. 3.1. The time keeping
display
a) the
date is
displayed
b) the se-
conds are
displayed
c) the dual
time is
displayed
d) the
stop-
watch is
displayed