Dive mode settings, Depth alarm – SUUNTO D9 User Manual

Page 46

5.2. DIVE MODE SETTINGS

This D9 has several User Defi nable Functions and depth and
time related alarms that you can set according to your perso-
nal preference. The dive mode settings are dependent on the
DIVE sub-mode chosen (Air, EAN, Gauge), so that e.g. nitrox
settings are only available in the DIVEean sub-mode.

To enter dive mode settings (Fig. 5.7) press the DOWN but-
ton for >2s when in DIVE mode. Then use the UP/DOWN but-
tons to toggle settings. Press SELECT to review/change set-
tings. Use SELECT to move between values and UP/DOWN
to alter the value. Exit using MODE.

NOTE! The settings cannot be activated until 5 minutes has
elapsed after the dive.

5.2.1. DEPTH ALARM

You can set one depth alarm in the dive computer (Fig 5.8).
The depth alarm is set to 40 m [131 ft] at the factory, but you
are able to adjust it according your personal preference or
switch it off. The depth range can be set from 3.0 m to 100 m
[9 ft to 328 ft] (Fig. 5.9.).

Fig. 5.15. Entering Personal
and Altitude settings.

Fig. 5.16. Setting Perso-
nal and Altitude adjust-
ment. Press scroll buttons
to change personal mode.
Use SELECT to accept.