Windsor Chariot iGloss Burnisher CB20 - Manual (Page 34)

TROUBLESHOOTING
86306300 CHARIOT BURNISHER 11/09/07 4-15
PROBLEM CAUSE SOLUTION
Battery disconnected Check all battery cable connections
Emergency shut-off activated Reset
Battery cables corroded Clean connections
No power to machine
Faulty key switch Replace switch
Low battery charge Charge batteries
Machine turned on with pedal not in
neutral position Allow pedal to return to neutral.
Restart
Tripped circuit breaker Reset circuit breaker
Controller overheated Allow cool down period
Loose motor connection Check wires and connections from controller to
motor
Faulty throttle circuit or potentiometer Check wires and connections from throttle to
controller and potentiometer resistance
Faulty drive reset circuit or switch Check wires, connections and switch
Faulty operator presence pedal
circuit or switch Check wires, connections and switch
Faulty platform circuit or switch Check wires, connections and switch
Brake over-ride engaged Disengage brake over-ride
Little or no propel
Faulty brake circuit or over-ride
switch Check wires, connections and switch
Machine does not change
speeds Faulty speed control circuit or switch Check wires, connections and switch
Forward speed only
Reverse speed only Faulty forward/reverse switch Replace switch
Deck won’t go up or down Circuit breaker tripped Reset circuit breaker
Fuse blown Replace fuse
Faulty switch or connection Check switch or connections
Pad motor won’t run
Faulty relay Check pad motor relay
Deck vibrates Pad off center Re-center or replace pad using pad install tool
Dust leaks from skirts Dust hose blocked Check for blockage and clear if needed