Vista Imaging Vista Routing User Manual
Page 57
Routing User Guide
Configuring Routing
 Partial matching can be used to allow VistARad to access images from multiple
destinations. For more information, see the next section.
…
[Workstation Settings]
WorkStation TimeOut minutes=0
ID=UNKnown
Location=UNKnown
VistaRad test mode=FALSE
CacheLocationID=DEMO
…
5
Save and close the file.
Making Multiple Destinations Accessible to VistARad
A VistARad workstation can be used to display images from multiple (local)
destinations. This is possible because partial matching is used when the
CacheLocationID
is compared to the names of routing destinations defined in the
NETWORK LOCATION
File (#2005.2).
For example, if a site is sending images to the destinations shown below, a VistARad
workstation with its
CacheLocationID
set to
Telerad
would be able to access both
destinations.
TeleradMain
TeleradBackup
Note that the partial matching used is based on leading characters. Continuing the above
example, a destination named
NewTelerad
would not be treated as a match for
workstations using
Telerad
as their
CacheLocationID
.
April 2006
VistA Imaging V. 3.0, Patch 18
49