Vista Imaging Vista Routing - Manual (Page 33)

Configuring Routing
This chapter assumes that routing software has been installed, and that an initial set
of routing rules have been defined.
This chapter explains how to configure a routing system. The following table lists the
configuration tasks described in this chapter.
Configuration Task Performed By
See
Page
…
Set up Imaging destinations All sites involved 26
Set up DICOM destinations All sites involved 37
Review/edit route priors logic Sending site 40
Image Gateway configuration Sending site 42
Routing Gateway configuration Sending site 43
Import routing rules Sending site 44
VistARad site parameter setup Sending site 47
VistARad workstation setup Receiving site 48
Alter configuration in response to
changes in routing system
All sites involved 50
A configuration checklist is also available in Appendix A .
April 2006 VistA Imaging V. 3.0, Patch 18 25