Vista Imaging Vista Routing User Manual
Page 41
Routing User Guide
Configuring Routing
PHYSICAL REFERENCE
The value of this field identifies the physical network location where routed images
will be stored. This value must contain the computer name and the share name of the
directory where routed images will be stored.
\\ISWIMG01\IMAGE1$\
\\TeleRad\Wichita$\
This value must be entered using UNC (Universal Naming Convention) standards.
This field is limited to 63 characters in length, must end in a backslash ( \ ), and the
part of the name that identifies the computer cannot contain punctuation.
TOTAL SPACE
SPACE USED
FREE SPACE
These fields are not used for routing. The Background Processor uses these fields and
will set values as needed.
OPERATIONAL STATUS
The value for this field can be
0
(off-line) or
1
(on-line). The routing software will set
this value appropriately as it is operating. When no connection can be established, the
routing software will set this field to
0
(off-line). Once this field is set to
0
, the routing
software will not attempt to reach the storage location referenced in this entry for 15
minutes. After 15 minutes have passed, the routing software will reset this field to
1
and then try to connect again.
STORAGE TYPE
The value of this field describes the media type for the storage location identified
above. For routing destinations, the value will be
MAGNETIC
.
HASH SUBDIRECTORY
The value of this field determines if routed image files are stored in one single
directory (value is
No
or empty), or in a hierarchy of directories (value is
Yes
). This
value should be set based on the needs of your site.
ABSTRACT
The value of this field indicates whether or not “abstract” files should be transmitted
to this destination. Abstract files (also known as thumbnail or icon files) are used by
Clinical Display workstations.
FULL
The value of this field indicates whether or not “full” files should be transmitted to
this destination. Full files contain the complete image, potentially at a reduced
resolution. For routing, this field should be set to
Yes
.
April 2006
VistA Imaging V. 3.0, Patch 18
33