Vista Imaging Vista Routing - Manual (Page 39)

Routing User Guide Configuring Routing
Imaging Destination Definition
Imaging Destination Definition using FileMan
The following steps explain how to create an Imaging destination using FileMan. For
information about values for specific fields, refer to page
32 . A destination definition
worksheet is also located on page 71 .
Editing the Network Location File at the sending site
1 Log into the VistA Hospital Information System.
2 Use FileMan to select the NETWORK LOCATION File (#2005.2) for editing.
Select OPTION: E ENTER OR EDIT FILE ENTRIES
INPUT TO WHAT FILE: 2005.2 NETWORK LOCATION (7 entries)
EDIT WHICH FIELD: ALL//
3 When you are prompted to select a network location, enter the name that you want
used for the destination.
Select NETWORK LOCATION: TESTDEST
Are you adding 'TESTDEST' as a new NETWORK LOCATION (the 11TH)? No// YES
 The name must be entered in upper case, cannot contain punctuation or spaces, and
cannot match the name of a DICOM destination.
4 At the next prompt, enter the computer name and share name of the storage location
you want used for this destination. This name references a folder defined as described
on page
28 .
PHYSICAL REFERENCE: \\VHAxxxxxx\images$\
5 At each new prompt, enter the desired values for each field. Be sure to enter Y at the
ROUTER prompt.
 Typical values for a routing destination are shown below. For more detailed
information about a particular field, enter "?" at the prompt, or refer to the next
section.
…
STORAGE TYPE: MAG MAGNETIC
TOTAL SPACE:
SPACE USED:
FREE SPACE:
April 2006 VistA Imaging V. 3.0, Patch 18 31