Uniden UBCD996T - Manual (Page 95)

95
Set Delay Time
Set Modulation
Set Attenuator
Set Data Skip
Set Step
Set C-Ch Only
Set Record
On
Adjust P25 Level
Search with Scan
Set Quick Key
Set Startup Key
Set Lockout
Set Hold Time
— lets you set the amount of time the scanner will delay before
continuing to search after a transmission ends.
— lets you set the custom search range’s modulation type.
— lets you set whether the scanner will attenuate reception by
20 dB during search.
— lets you set whether the scanner will skip data transmissions
during search.
— lets you set the custom search range’s step (the gap between
frequencies).
— lets you search for a Motorola control channel. If it finds one,
the scanner scans the system.
— if during your listening to the selected service, if a transmission is
received, choosing will send an audio signal to the connected audio recording
device.
— adjusts the digital decode threshold to match the
transmission you are hearing when it receives a strong signal and has a high
decode rate.
sets whether the scanner includes the custom search
during scanning. If unlocked, the scanner first scans all selected systems, then
searches the selected service searches for the selected hold time (0-255 seconds).
Within this menu item are the following settable options
— lets you assign a Quick Key for the custom search range.
— lets you decide which custom search range should be
unlocked and scanned at power up
— lets you lock the custom search range for this session or
permanently as with any other L/O action.
— sets how long (seconds) the custom search range is checked
before the scanner moves to the next programmed entry.
When you press the UBCD996T starts a scan of those sites,
channels, etc you have manually programmed or the Uniden preprogrammed data
for your metropolitan area that are unlocked and have their System Quick key
enabled.
—
[SCAN/SEARCH]
Search With Scan