Uniden UBCD996T - Manual (Page 62)

62
Programming Your Scanner
To get the most out of your UBCD996T you can organize frequencies into
programmed radio systems.
1. Plan the system.
2. Program the system into your scanner according to the plan you prepared in
Step 1.
You can store up to 6000 channels in up to 500 systems.
Each trunking system can have up to 256 sites and up to 250 trunked channels
(TGID). Each conventional system can have up to 1000 channels.
Your scanner can have up to a total of 1000 sites. Each system can have up to 20
channel groups.
The following table provides you the information to successfully perform various
steps connected with programming each of the systems: Conventional, Motorola,
EDACS, and LTR. Some operations are common to all of the systems while some
are specific to a given system. Use the following table to quickly locate the step you
want or need to perform (where required), the reference page for that step, and to
which system or systems it applies.
To edit an existing system, use the menu to navigate to the system setting you
want to change. This section assumes you are programming a new system.
Programming radio systems is completed in two major steps. Don’t skip either
step!
General Notes