Uniden UBCD996T - Manual (Page 67)

67
Programming Trunked Radio Systems
Programming System Settings
[MENU]
Then, select the system type:
— Motorola Type I systems
— Motorola Type II and APCO 25 systems
— EDACS Wide and Narrow systems
— EDACS SCAT systems
— LTR Systems
The scanner creates an empty system with a default name of Note
that “n” is a number that increments as you add new systems. The “x” on the right
side of the display is M for Motorola system, E for EDACS systems, and L for LTR
systems. After creating the system:
1. Set the system-level settings in “Programming System Settings” that apply to the
type of system you selected.
2. Set up at least one site for the system as described in “Programming Sites”
on Page76.
3. To scan specific channels, create one or more channel groups with channels as
described in “Programming Channel Groups.”
Each system name can be up to 16 characters. Abbreviate as necessary to fit. For
Motorola and EDACS Wide/Narrow systems, the system name only appears in the
scanner menu’s Program System listings. It is not shown during scanning. For other
systems, the system name alternates with the Channel group when the scanner
stops on a channel.
The default system names include the following letter in the 16th position to indicate
the system type:
= Motorola; = EDACS; = LTR; = Conventional;
Program System
New System
MOT TYPE1
MOT TYPE2/P25
EDCS WIDE/NARROW
EDCS SCAT
LT
System n x.
M E L C
Editing the System Name MECL