Uniden UBCD996T User Manual

Page 107

107

g Q

This feature sets whether the scanner tries to tune to a repeater output frequency

during Custom Search, Quick Search, or Close Call operation when it detects a

transmission on a repeater input frequency. Since you can normally only hear one

side of a conversation when you listen to an input frequency transmission, turning

this feature on can let you hear both sides of the conversation where a standard

difference frequency is set between the input and the output, to and from the

repeater.

— The scanner automatically applies repeater reverse to detected transmissions.

If the scanner detects the transmission on the output frequency, it beeps,

appears, and it remains on the output frequency until transmissions end. If it

does not detect a transmission on the output frequency, it remains on the original

frequency.

— The scanner does not try to find the output frequency.

This value sets how many hits the scanner will automatically store when it is in either

Search and Store or Close Call Auto Store mode. Use the number keys to enter a

value from 1 - 256, then press . The default value is 100.

When the scanner exceeds the maximum number of hits you set, it stops the auto-

store operation.

This setting controls the modulation method used for the frequency band and for

Quick Search and Close Call operations. In most cases, if you leave this set to

, the scanner automatically selects the correct modulation type for the system

you are programming.

— the scanner uses the default modulation for the frequency band. The

default setting is

Repeater Find

Off

Repeater

Found

Off

Srch/CloCall Opt

Max Auto Store

Srch/CloCall Opt

Set Modulation

Auto

Setting the Maximum Auto Store Value

Setting the Modulation Type

[MENU]

Auto