Uniden UBCD996T User Manual

Page 109

109

Setting the Delay Time

Setting the Search Frequency Step

Setting Record

Adjust P25 Level

[MENU]

RECORD OUT

This setting determines how long the scanner waits after a transmission ends before

resuming Quick Search or Close Call operation.

— The scanner waits the set amount of time after the transmission ends

before resuming. The default setting is 2 sec.

— The scanner resumes immediately when the transmission ends.

This setting lets you select the frequency step used for setting the channels.

— The step is based on the band (see the table at the front of the manual).

This is also the default setting.

You can set the RECord Output jack to provide an audio signal to a sound recording

device (tape, PC, flash memory) for live recording of transmissions.

— enables an output to an audio recorder at the

jack.

— disables an audio signal at the output jack.

You can select the best threshold for the APCO mode.

g Q

Srch/CloCall Opt

Set Delay Time

1-5 sec

Off

Srch/CloCall Opt

Set Step

Auto

5.0 kHz, 6.25kHz,

7.5 kHz,8.33kHz,

10.0 kHz, 12.5 kHz,

15.0 kHz, 20.0 kHz,

25.0 kHz, 50.0 kHz,

100.0 kHz

Srch/CloCall Opt

Set Record

Off

The scanner uses the selected step.