Unitech PA950 - Manual (Page 194)

21-194
Enter a Name
1. If you want, in Name, edit the name of the device with which you are
creating a bond. You may use any name.
2. Tap Finish.
See Also: About Bonds
Enter a PIN
Accept a Bond
1. Make sure that Bluetooth is turned on and in discoverable mode.
2. When prompted to bond with the other device, tap Yes.
3. In PIN, enter a PIN of between 1 and 16 characters, and tap Next.
You must enter the same PIN that was entered on the device
requesting the bond.
4. If you want, in Name, edit the name of the device requesting the
bond.
5. Tap Finish.
The bond is created. You can now exchange information with
the other device.
See Also: Making Your Device Discoverable
About Bonds
Bonding With Other Devices
Beaming Information With Bluetooth
Receiving a Bluetooth Beam