Toshiba B-SA4TP SERIES - Manual (Page 91)

7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33048
7.1 Media
E7- 1
7. SUPPLY SPECIFICATIONS
7.1 Media
Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a
problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service
representative.
7.1.1 Media Type
Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table
below shows size and shape of the media available for this printer.
[Unit: mm]
Label dispensing mode
Item
Batch mode Strip mode Cut mode
Thermal direct 10.0 – 999.0
c Media pitch
Thermal transfer 15.0 – 999.0
19.0 – 999.0 19.0 - 999.0
Thermal direct 8.0 – 997.0
d Label length
Thermal transfer 13.0 – 997.0
17.0 – 997.0 16.0 – 997.0
Thermal direct 25.0 – 118.0
e Media width/backing paper width
Thermal transfer 25.0 – 114.0
Thermal direct 22.0 – 115.0
f Label width
Thermal transfer 22.0 – 111.0
g Gap length 2.0 – 20.0 2.0 – 5.0 3.0 – 20.0
h Black mark length (Tag paper) 2.0 – 10.0
i Maximum effective print width 104.0 (200-dpi type), 105.7 (300-dpi type)
Thermal direct 6.0 – 995.0
Label
Thermal transfer 11.0 – 995.0
15.0 – 995.0 14.0 - 995.0
Thermal direct 8.0 – 997.0
j Effective print length
Tag paper
Thermal transfer 13.0 – 997.0
----- 17.0 – 997.0
k Print speed up/slow down area 1.0
Thermal direct 0.08 – 0.17 (Note 4) 0.13 – 0.17 0.08 – 0.17 (Note 4)
Thickness
Thermal transfer 0.1 – 0.17 (Note 4) 0.13 – 0.17 0.1 – 0.17 (Note 4)
Maximum outer roll diameter Ø152.4
Roll direction Inside/Outside
Inner core diameter Ø38, 40, 42, 76.2±0.3
Label Tag paper
Cut position
Cut position
Stop
position
Stop
position
Feed Direction
Black Mark
(on reverse side) Black Mark
(on reverse side)
h
e
c
e
g h
c
d
i
i
k
k
f
j