Toshiba B-SA4TP SERIES - Manual (Page 15)

2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.2 Connecting the Power Cord
E2- 2
2.1 Installation
2.2 Connecting the
Power Cord
To insure the best operating environment, and to assure the safety of the
operator and the equipment, please observe the following precautions.
• Operate the printer on a stable, level, operating surface in a location
free from excessive humidity, high temperature, dust, vibration or
direct sunlight.
• Keep your work environment static free. Static discharge can cause
damage to delicate internal components.
• Make sure that the printer is connected to a clean source of AC
Power and that no other high voltage devices that may cause line
noise interference are connected to the same mains.
• Assure that the printer is connected to the AC mains with a three-
prong power cable that has the proper ground (earth) connection.
1. Make sure that the printer Power Switch is in the OFF (
{ ) position.
Connect the Power Cord to the printer as shown in the figure below
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
[Example of US Type] [Example of EU Type]
CAUTION!
As a Power Cord is not supplied
with the printer, please purchase
an approved on that meets the
safety standard of each country.
(Refer to APPENDIX 3.)
Power Cord Power Switch
Power Cord
Power Cord
CAUTION!
As the enclosure of this product
is made from plastic, do not
install the printer where it might
be exposed to oil or solvent.