Toshiba B-SA4TP SERIES - Manual (Page 42)

2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-29
2.7.3 IP Address Setting
(TCP/IP) (Cont.)
(6) DHCP Client ID
This parameter is to set a DHCP client ID.
ASCII code and Hex. code correspondence table
Upper 4 bits
Lower 4 bits
2 3 4 5 6 7
0 SP 0 @ P ` p
1 ! 1 A Q a q
2 “ 2 B R b r
3 # 3 C S c s
4 $ 4 D T d t
5 % 5 E U e u
6 & 6 F V f v
7 ‘ 7 G W g w
8 ( 8 H X h x
9 ) 9 I Y i y
A * : J Z j z
B + ; K [ k {
C , < L \ l |
D - = M ] m }
E . > N ^ n
F / ? O _ o
SP = Space
(Example) To enter “TOSHIBA” in Hex. code:
54 4F 53 48 49 42 41
When the system mode settings have been completed, turn off the printer.
<7>IP ADDRESS
DHCP CLIENT ID
MODE ASCII
DHCP CLIENT ID MODE HEX
DHCP CLIENT ID
4142434445464748
494A4B4C4D4E4F50
[PAUSE]
[PAUSE]
[FEED] or [RESTART]
[PAUSE]
Hex. Code
MODE ASCII
ABCDEFGHIJKLMNOP
ASCII Code
[PAUSE]
Enter a character or a value for each of 1st byte to 16th
byte sequentially using the [FEED] or [RESTART] key.
[PAUSE]
NOTES:
1. Code used to enter a DHCP
client ID is selectable between
ASCII code (alphanumeric) and
Hex code.
2. Set a character or value for
each byte by using the
[RESTART] or [FEED] key.
[RESTART] key: Increment
[FEED] key: Decrement
3. Press the [PAUSE] key to enter
the next byte. Repeat this until
16th byte is entered.
4. After the 16th byte is set, press
the [PAUSE] key to store the
entered DHCP client ID. At this
time, the display will turn to
<7>IP ADDRESS.