Toshiba B-SA4TP SERIES - Manual (Page 30)

2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-17
2.7.1 How to Enter the
System Mode
2.7.2 Parameter Setting
This section describes how to enter the System Mode.
1. Turn on the printer and confirm that “ONLINE” appears on the LCD
Message Display.
2. Press the [PAUSE] key to pause the printer.
3. Hold down the [RESTART] key for three seconds until “<1>RESET”
is displayed.
4. Press the [FEED] key, and “<2>PARAMETER SET” appears on the
LCD Message Display.
In this section, how to select a language and how to set the
communication parameters are described. When further information is
required, refer to the B-SA4T Series Key Operation Specification.
While “<2>PARAMETER SET” is displayed on the LCD Message
Display, press the [PAUSE] key to enter the Parameter Setting Mode.
NOTE:
If the [PAUSE] key is pressed with “<1>RESET” being displayed, the
printer will turn to an idle state and the message will change to “ONLINE”.
ONLINE
B-SA4T V1.0
P
R
PAUSE
B-SA4T V1.0
<2>PARAMETER SET
P