Toshiba Programmable Logic Controller V200 - Manual (Page 14)

Page 6
Handling and Storage
• Use proper lifting techniques when moving the V200; including properly sizing up the
load, and getting assistance if required.
• Store in a well-ventilated covered location and preferably in the original carton if the
equipment will not be used upon receipt.
• Store in a cool, clean, and dry location. Avoid storage locations with extreme
temperatures, rapid temperature changes, high humidity, moisture, dust, corrosive
gases, or metal particles.
• Do not store the unit in places that are exposed to outside weather conditions (i.e., wind,
rain, snow, etc.).
• Store in an upright position as indicated on the shipping carton.
• Include any other product-specific requirements.
Disposal
Never dispose of electrical components via incineration. Contact your state environmental
agency for details on disposal of electrical components and packaging in your area.
0.4 Installation Precautions
Location and Ambient Requirements
• Adequate personnel working space and adequate illumination must be provided for
adjustment, inspection, and maintenance of the equipment (refer to NEC Article 110-34).
• Avoid installation in areas where vibration, heat, humidity, dust, fibers, steel particles,
explosive/corrosive mists or gases, or sources of electrical noise are present.
• The installation location shall not be exposed to direct sunlight.
• Allow proper clearance spaces for installation. Do not obstruct the ventilation openings.
Refer to the recommended minimum installation dimensions as shown on the enclosure
outline drawings.
• The ambient operating temperature shall be between 0 ° and 50° C (32° and 122° F).
Mounting Requirements
• Only Qualified Personnel should install this equipment.
• Install the unit in a secure upright position in a well-ventilated area.
• A noncombustible insulating floor or mat should be provided in the area immediately
surrounding the electrical system at the place where maintenance operations are to be
performed.