Toshiba M300 - Manual (Page 124)

6-16 User’s Manual
Power and Power-Up Modes
■ Disable (button)
Click this button to invalidate the token. You cannot revalidate old
tokens, but you can use the same SD cards to create new tokens.
Supervisor password
If you set a supervisor password, some functions might be restricted when
a user logs on with the user password. To set a supervisor password,
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\Windows
Utilities\SVPWTool\TOSPU.EXE
This utility lets you do the following:
■ Register, delete or change the supervisor password.
■ Create or invalidate a supervisor password token.
■ Specify restrictions for general users.
Starting the computer by password
If you registered a password, there are two ways to start the computer:
■ Insert an SD card token before you turn on the computer. The computer
will start normally, without displaying a password prompt.
■ Enter the password manually.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
Getting Started . The
following message will appear in the LCD:
S
Password=
2. Enter the Password.
3. Press Enter.
After using the token created for authentication, do not leave it inserted in
the SD card slot, ensure that the token is removed from the slot and stored
in a safe location. If the token is left in the slot, there is a danger of theft or
a third party using it for authentication and operating the user's computer
(resulting in extraction, modification or deletion of data) when the user is
not at their desk.
This function in the TOSHIBA Password Utility lets you invalidate only
supervisor tokens.
The password is necessary only if the computer was shut down in boot
mode. It is not needed in Standby mode.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.